DS1075 Просмотр технического описания (PDF) - Dallas Semiconductor -> Maxim Integrated

Номер в каталоге

Компоненты Описание

Список матч

DS1075

EconOscillator/Divider

Dallas Semiconductor -> Maxim Integrated 

Figure 7

DS1075

Depending on the relative timing of the SELX signal and the internal clock, there may be up to one full

cycle of tI on the output after the falling edge of SELX . Then, the “low” time (tLOW) between output

pulses will be dependent on the relative timing between tI and tE. The time interval between the falling

edge of SELX and the first rising edge of the externally derived clock is tSIE. Approximate maximum and

minimum values of these parameters are:

tLOW (min) = tI/2

tLOW (max) = tI/2 + tE

tSIE (min) = tI/2

tSIE (max) = 3 tI/2 + tE

NOTE:

In each case there will be a small additional delay due to internal propagation delays.

FROM EXTERNAL TO INTERNAL CLOCK

This is accomplished by a low to high transition on the SELX pin. In this case the switch is level

triggered, to allow for the possibility of a clock signal not being present at OSCIN. Note therefore, that if

a constant high-level signal is applied to OSCIN it will not be possible to switch over to the internal

reference. (Level triggering was not employed for the switch from internal to external reference as this

approach is slower and the internal clock may be running at a much higher frequency than the maximum

allowed external clock rate). When SELX is high and a low level is sensed on EXTCLK, OUT0 will be

held low until a falling edge occurs on INTCLK, then the next rising edge of INTCLK will be routed

through to OUT0.

Figure 8

Depending on the relative timing of the SELX signal and the external clock, there may be up to one full tE

high period on the output after the rising edge of SELX . Then, the “low” time (tLOW) between output

pulses will be dependent on the relative timing between tI and tE. The time interval between the falling

8 of 18

Share Link: