ACT-D1M96S Просмотр технического описания (PDF) - Aeroflex Corporation

Номер в каталоге

Компоненты Описание

Список матч

ACT-D1M96S

High Speed Multichip Module 96 MegaBit 3.3V Synchronous DRAM

Aeroflex Corporation 

Absolute Maximum Ratings1

Symbol

Rating

Range

Units

VCC

Supply Voltage

-0.5 to 4.6

V

VCCQ

VRANGE

TBIAS

TSTG

ISHORT

PW

Supply Voltage range for output drivers

Voltage range on any pin with respect to VSS

Case Temperature under Bias 2

Storage Temperature

Short-Circuit Output Current

Power Dissipation

-0.5 to 4.6

V

-0.5 to 4.6

V

-55 to +125

°C

-65 to +150

°C

50

mA

4.2

W

1. Stresses above those listed under "Absolute Maximums Rating" may cause permanent damage to the device. This is a stress rating only and functional operation of

the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating

conditions for extended periods may affect device reliability.

2. The temperature rise of θjc is negligible due to the low duty cycle during testing.

Recommended Operating Conditions

Symbol

Parameter

VCC

Supply Voltage

VCCQ Supply Voltage range for output drivers

VSS

Supply Voltage

VSSQ Supply Voltage range for output drivers

VIH

Input High Voltage

VIL

Input Low Voltage 1

TC

Operating Temperature (Case) 2

1. VIL Minimum = 1.5Vac (Pulsewidth < 5ns)

2. The temperature rise of θjc is negligible due to the low duty cycle during testing.

Minimum

3

3

2

-0.3

-55

Typical

3.3

3.3

0

0

Maximum

3.6

3.6

VCC + 0.3

0.8

+110

Units

V

V

V

V

V

V

°C

DC Characteristics

(VCC = 3.3V ±10%; Tc =-55°C to +110°C, See Notes 1 & 5)

Parameter

Symbol

Conditions

Output Low Voltage

Output High Voltage

Input current (Leakage)

Output current (Leakage)

Precharge standby

current in

non-power-down mode

VOL

VOH

II

IO

ICC2N

ICC2NS

IOL = 2mA

IOH = -2mA

0V < VI < VCC + 0.3V, All other pins = 0V to VCC

0V < VO < VCC + 0.3V, Output disabled

CKE > VIH MIN, tCK = 20ns (See note 2)

CKE > VIH MIN, CLK < VIL MAX, tCK = ∞

(See note 3)

1. All specifications apply to the device after power- up initialization. All control and address inputs must be stable and valid.

2. Control, DQ, and address inputs change state only once every 40 ns.

3. Control, DQ, and address inputs do not change (stable).

4. All ICC parameters measured with VCC, not VCCQ.

5. The temperature rise of θjc is negligible due to the low duty cycle during testing.

Min

2.4

-10

-10

Max Units

0.4

V

V

+10 µA

+10 µA

180 mA

40 mA

Aeroflex Circuit Technology

8

SCD3369-1 REV C 5/31/00 Plainview NY (516) 694-6700

Share Link: