TC58NVG1S3BFT00/TC58NVG1S8BFT00
Auto Block Erase
The Auto Block Erase operation starts on the rising edge of WE after the Erase Start command “D0h” which
follows the Erase Setup command “60h”. This two-cycle process for Erase operations acts as an extra layer of
protection from accidental erasure of data due to external noise. The device automatically executes the Erase
and Verify operations.
RY / BY
60
Block Address
input: 3 cycles
D0
Erase Start
command
Busy
70
Status Read
command
Pass
I/O
Fail
22
2003-10-30A