DS1077LU-40 Просмотр технического описания (PDF) - Dallas Semiconductor -> Maxim Integrated

Номер в каталоге

Компоненты Описание

Список матч

DS1077LU-40

3V EconOscillator/Divider

Dallas Semiconductor -> Maxim Integrated 

TABLE 5

BIT VALUE

0 000 000 000*

0 0 00 0 00 001

—

—

—

—

1 111 111 111

*Default Condition

DIVISOR (N)

2

3

—

—

—

—

1025

DS1077L

BUS WORD

NAME

—

—

—

—

WC

A2

A1

A0

Factory Default 0*

0*

0*

0*

0

0

0

0

*These bits are reserved and must be set to zero.

A0, A1, A2

(Default Setting = 000)

These are the device select bits that determine the address of the device.

WC

(Default Setting WC = 0)

This bit determines when/if the EEPROM is written to after register contents have been changed.

If WC = 0, the EEPROM is automatically written after a write register command.

If WC = 1, the EEPROM is only written when the WRITE command is issued.

Regardless of the value of the WC bit, the value of the BUS register (A0, A1, and A2) is always

immediately written to the EEPROM.

2-WIRE SERIAL DATA BUS

The DS1077L supports a bidirectional 2-wire bus and data transmission protocol. A device that sends data

onto the bus is defined as a transmitter, and a device receiving data as a receiver. The device that controls

the message is called a “master.” The devices that are controlled by the master are “slaves.” The bus must

be controlled by a master device that generates the serial clock (SCL), controls the bus access, and

generates the START and STOP conditions. The DS1077L operates as a slave on the 2-wire bus.

Connections to the bus are made via the open-drain I/O lines, SDA and SCL. A pullup resistor (5k) is

connected to SDA.

The following bus protocol has been defined (see Figure 2):

§ Data transfer may be initiated only when the bus is not busy.

§ During data transfer, the data line must remain stable whenever the clock line is high. Changes in

the data line while the clock line is high will be interpreted as control signals.

7 of 20

Share Link: