CMX624 Просмотр технического описания (PDF) - CML Microsystems Plc
Номер в каталоге
Компоненты Описание
Список матч
CMX624 Datasheet PDF : 26 Pages
| |||
V23 / Bell 202 Modem
CMX624
Received data from the FSK Demodulator goes into the receive part of the UART block, where it is
handled in one of two ways depending on the setting of bit 7 of the FSK MODE Register:
If the bit is ‘0’ (‘Rx Sync’ mode) then the receive part of the UART block will simply take 8
consecutive bits from the Demodulator and transfer them to the RX DATA Register (the first bit
going into the D0 position). Note that this mode is intended for detection of simple data patterns
such as ‘1010…’ or continuous Mark or Space signals, the CMX624’s receive data clock
extraction circuits are not adequate to support a true synchronous receive data mode of operation.
If bit 7 of the FSK MODE Register is ‘1’ (‘ Rx Async’) then the received data output of the FSK
Demodulator is treated as 75, 150 or 1200 bps asynchronous characters each comprising:
A Start bit (Space).
7 or 8 Data bits as determined by bit 0 of the SETUP Register. These bits will be placed
into the RX DATA Register with the first bit received going into the D0 position.
An optional Parity bit as determined by bits 1 and 2 of the SETUP Register. If Parity is
enabled (bit 2 of the SETUP Register = ‘1’) then bit 7 of the FLAGS Register will be set to
‘1’ if the received parity is incorrect.
At least one Stop bit (Mark).
Bit 2 (Rx Data Ready) of the FLAGS Register will be set to ‘1’ every time a new received value is loaded
into the RX DATA Register. If the previous contents of the RX DATA Register had not been read out over
the ‘C-BUS’ before the new value is loaded from the UART then bit 3 (Rx Data Overflow) of the FLAGS
Register will also be set to ‘1’.
Figure 6b Receive UART Function (Async)
2003 CML Microsystems Plc
12
D/624/7
Share Link: 