CS61881-IB Просмотр технического описания (PDF) - Cirrus Logic

Номер в каталоге

Компоненты Описание

Список матч

CS61881-IB

Octal E1 Analog Front End

Cirrus Logic 

CS61881

Control

RPD - Receiver Power Down, LQFP Pin 10, BGA Pin E1

When RPD is Low, the complete receive path for all ports is powered down the output pins

RPOS, RNEG and RCLK are switched to the high impedance state.

TXOE - Transmitter Output Enable, LQFP Pin 114, BGA Pin E14

When TXOE is asserted Low, all of the TX drivers are forced to a high impedance state in

1 µS (max). All other internal circuitry remains active.

RPS - Receiver Polarity Select, LQFP Pin 115, BGA Pin E13

This pin is used to set the polarity of RPOS/RNEG. When RPS is High, RPOS/RNEG has an

active high output polarity. When RPS is low, RPOS/RNEG have an active Low polarity.

LOOP0 - Loopback Mode Select Port #0, LQFP Pin 21, BGA Pin G2

This pin selects the loopback mode for LIU transceiver 0. The mode is selected as follows:

No Loopback - LOOP0 is left open (unconnected)

Local Loopback - LOOP0 is tied High. In this mode, data transmitted on TTIP0 and TRING0

is looped back into port 0’s receiver and output on RPOS0 and RNEG0. Data present on RTIP0

and RRING0 is ignored.

Remote Loopback - LOOP0 is tied Low. In this mode, data received on RTIP0 and RRING0 is

looped back for retransmission on TTIP0 and TRING0. Data on TPOS0 and TNEG0 is

ignored.

LOOP1 - Loopback Mode Select Port #1, LQFP Pin 22, BGA Pin H3

LOOP2 - Loopback Mode Select Port #2, LQFP Pin 23, BGA Pin H2

LOOP3 - Loopback Mode Select Port #3, LQFP Pin 24, BGA Pin J4

LOOP4 - Loopback Mode Select Port #4, LQFP Pin 25, BGA Pin J3

LOOP5 - Loopback Mode Select Port #5, LQFP Pin 26, BGA Pin J2

LOOP6 - Loopback Mode Select Port #6, LQFP Pin 27, BGA Pin J1

LOOP7 - Loopback Mode Select Port #7, LQFP Pin 28, BGA Pin K1

18

DS451PP3

Share Link: