General Description
NT6861 is a monitor component mC for auto-sync and digital controlled applications. It contains a 6502 8-bit CPU core, 256 bytes of RAM used as working RAM and stack area, 24K bytes of ROM maximum for programming, 14-channel 8-bit PWM D/A converters, 2-channel A/D converters for key detection saving I/O pins, one 8 bit pre-loadable base timer, internal Hsync and Vsync signals processor providing mode detection, watch-dog timer preventing system from abnormal operation, and an I2C bus interface.
Users can store EDID data in the 128 bytes of RAM for DDC1/2B, so that users can save the cost of dedicated EEPROM for EDID. Half frequency output function can save external one-shot circuit. All of these designs create savings in component costs.

FEATUREs
■ 40 pin DIP & 42 pin SDIP package
■ Operating Voltage Range: 4.5V to 5.5V
■ CMOS technology for low power consumption
■ Crystal oscillator or ceramic resonator* available
■ 6502 8-bit CMOS CPU core
■ 8MHz operation of frequency
■ 4/8/12/16/24K bytes ROM are available
■ 256 bytes of RAM (which stores EDID for DDC1/2B)
■ One 8-bit pre-loadable base timer
■ 14 channels of 8 bit PWM outputs:
   6 channel with 5V open drain and 8 channel with 12V
   open drain
■ 2 channel A/D converters with 6-bit resolution
■ 24 bi-directional I/O port pins and 1 I/P pin
■ Hsync/Vsync signal processor
■ Hardware sync signals polarity & freq. evaluator
■ Built-In I2C bus interface
■ Supporting VESA DDC1/2B function
■ Six-interrupt sources
   - INTV (Vsync INT)
   - INTE (External INT with rising edge trigger)
   - INTMR (Timer INT )
   - INTA (Slave Address Matched INT)
   - INTD (Shift Register INT)
   - INTS (SCL GO-LOW INT)
■ Hardware watch-dog timer function