■ GENERAL DESCRIPTION
The MBM29LV200TC/BC are a 8M-bit, 3.0 V-only Flash memory organized as 256K bytes of 8 bits each or 128K words of 16 bits each. The MBM29LV200TC/BC are offered in 48-pin TSOP(I) and 44-pin SOP packages. These devices are designed to be programmed in-system with the standard system 3.0 V VCC supply. 12.0 V VPP and 5.0 V VCC are not required for write or erase operations. The devices can also be reprogrammed in standard EPROM programmers.

■ FEATURES
• Single 3.0 V read, program, and erase
    Minimizes system level power requirements
• Compatible with JEDEC-standard commands
    Uses same software commands as E2PROMs
• Compatible with JEDEC-standard world-wide pinouts
    48-pin TSOP(I) (Package suffix: PFTN – Normal Bend Type, PFTR – Reversed Bend Type)
    44-pin SOP (Package suffix: PF)
• Minimum 100,000 program/erase cycles
• High performance
    70 ns maximum access time
• Sector erase architecture
    One 8K word, two 4K words, one 16K word, and three 32K words sectors in word mode
    One 16K byte, two 8K bytes, one 32K byte, and three 64K bytes sectors in byte mode
    Any combination of sectors can be concurrently erased. Also supports full chip erase
• Boot Code Sector Architecture
    T = Top sector
    B = Bottom sector
• Embedded EraseTM Algorithms
    Automatically pre-programs and erases the chip or any sector
• Embedded ProgramTM Algorithms
    Automatically writes and verifies data at specified address
• Data Polling and Toggle Bit feature for detection of program or erase cycle completion
• Ready/Busy output (RY/BY)
    Hardware method for detection of program or erase cycle completion
• Automatic sleep mode
    When addresses remain stable, automatically switch themselves to low power mode
• Low VCC write inhibit ≤ 2.5 V
• Erase Suspend/Resume
    Suspends the erase operation to allow a read in another sector within the same device
• Sector protection
    Hardware method disables any combination of sectors from program or erase operations
• Sector Protection set function by Extended sector Protect command
• Temporary sector unprotection
    Temporary sector unprotection via the RESET pin