■GENERAL DESCRIPTION
The MBM29F080A is a 8 M-bit, 5.0 V-Only Flash memory organized as 1 M bytes of 8 bits each. The 1 M bytes of data is divided into 16 sectors of 64 K bytes for flexible erase capability. The 8 bit of data will appear on DQ0 to DQ7. The MBM29F080A is offered in a 48-pin TSOP(I), 40-pin TSOP, and 44-pin SOP packages. This device is designed to be programmed in-system with the standard system 5.0 V VCCsupply. A 12.0 V VPPis not required for program or erase operations. The device can also be reprogrammed in standard EPROM programmers.

■FEATURES
• Single 5.0 V read, write, and erase
   Minimizes system level power requirements
• Compatible with JEDEC-standard commands
   Pinout and software compatible with single-power supply Flash
   Superior inadvertent write protection
• 48-pin TSOP(I) (Package Suffix: PFTN-Normal Bend Type, PFTR-Reverse Bend Type)
   40-pin TSOP(I) (Package Suffix: PTN-Normal Bend Type, PTR-Reversed Bend Type)
   44-pin SOP (Package Suffix: PF)
• Minimum 100,000 write/erase cycles
• High performance
   55 ns maximum access time
• Sector erase architecture
   Uniform sectors of 64 K bytes each
   Any combination of sectors can be erased. Also supports full chip erase.
• Embedded Erase™ Algorithms
   Automatically pre-programs and erases the chip or any sector
• Embedded Program™ Algorithms
   Automatically programs and verifies data at specified address
•DataPolling and Toggle Bit feature for detection of program or erase cycle completion
• Ready/Busy output (RY/BY)
   Hardware method for detection of program or erase cycle completion
•Low VCCwrite inhibit ≤3.2 V
• Hardware RESETpin
   Resets internal state machine to the read mode
• Erase Suspend/Resume
   Supports reading or programming data to a sector not being erased
• Sector group protection
   Hardware method that disables any combination of sector groups from write or erase operation (a sector group consists of 2 adjacent sectors of 64 K bytes each)
• Temporary sector groups unprotection
  Temporary sector unprotection via the RESET pin