[TEGAM]

Automated Audio Test System Advantages

TEGAM SG 5010 and AA 5001 programmable instruments in a computer controlled test system will make critical audio measurements consistently, accurately, and in two to four seconds each. Even complex tests can be made by non-technically-skilled operators since the procedures are controlled by software in the controller. And, permanent graphic or tabular records of test results can be produced at very low cost.

Automated Audio Test System Advantages
• Fast, Accurate, Repeatable Measurements.
• Lower Required Operator Skill.
• Automatic, Low-cost Documentation of Test Results in Graphic or Tabular Form.

Instrument Performance Features
• Extremely low residual noise and distortion permit measurements on top-grade professional and consumer audio equipment.
• Performs all standard audio tests — THD, IMD (SMPTE, DIN, CCIF difference tone), gain/loss, signal to-noise ratio.
• Analyzer input fully balanced, oscillator output balanced or unbalanced, floating or grounded, 50/150/600 Ω to match all types of audio equlpment.
• Automatic swept measurements possible without IEEE-488 controller.
• Four-or-more digit synthesized frequency, 0.01% guaranteed accurate.
• Fully programmable filter and detector selection to meet a wide variety of measurement standards.
• High level oscillator output to test head room, clipping thresholds of line level devices.
• Ten non-volatile stored generator setups.
• Generator includes burst, square wave, and amplifier modes.