XE5692H-ITR Просмотр технического описания (PDF) - Unspecified
Номер в каталоге
Компоненты Описание
Список матч
XE5692H-ITR Datasheet PDF : 22 Pages
| |||
XE5692H AT Commands
+MS - Select Modulation -
AT+MS sets the modulation and data rates to
be supported by the modem. The command
format is: AT+MS=a, b, c, d, e, f<CR>
a - modulation type
V21 - V.21 (300 bps)
V22 - V.22 (1200 bps)
V.22B - V.22bis (1200 or 2400 bps)
V32 - V.32 (4800 or 9600 bps)
V32B - V.32bis (4800 to 14,400 bps)
V34 - V.34 (16,800 to 33,600 bps)
V90 - V.90 (to 56,000 bps)
V92 - V.92 (to 56,000 bps)
b - Automode Detection
0 - Automatic Negotiation Disabled
1 - Automatic Negotiation Enabled
c - Min receive data rate (300-56000 bps)
d - Max receive data rate (300-56000 bps)
e - Min transmit data rate (300-56000 bps)
f - Max transmit data rate (300-56000 bps)
+VCID=n - Caller ID Enable
n=0 No Caller ID *
n=1 Formatted Caller ID Data presented
n=2 Raw Caller ID Data presented
+VCDT=n - Caller ID Type
n=0 On only after first ring
n=1 CID Always On
n=2 UK CID Format
n=3 Japanese CID Format
XE5692H REGISTER SETTINGS
S0 Answer on nth Ring: S0 sets the modem
to automatically answer on the nth ring.
Setting S0 to 0 disables automatic answer.
Range: 0 to 255
Units Rings
Default 0
S3 Line Termination Character: S3
determines the ASCII character which will
terminate commands and modem responses.
Range: 0 to 127
Units ASCII Character
Default 13 (Carriage Return)
S1 Ring Count: S1 is a read-only register
showing the number of rings detected. If no
ring is detected within 8 seconds, S1 is reset.
Range: 0 to 255
Units Rings
Default 0
S2 Escape Character: S2 sets the ASCII
escape character. Values of 0-127 select
valid characters; values from 128 to 255
disable the escape sequence.
Range: 0 to 255
Units ASCII Character
Default 43 (+)
S4 Line Feed Character: S4 sets the ASCII
character to act as a line feed character in
modem responses.
Range: 0 to 127
Units ASCII Character
Default 10 (Line Feed)
S5 Backspace Character: S5 defines the
ASCII character used as a backspace to
edit the command line.
Range: 0 to 127
Units ASCII Character
Default 8 (Back Space)
XECOM
(15)
XE5692H
Share Link: 