XRD66092AID Просмотр технического описания (PDF) - Exar Corporation

Номер в каталоге

Компоненты Описание

Список матч

XRD66092AID

CMOS 750 KSPS, 12-Bit Analog-to-Digital Converter with Serial Logic Interface Port

Exar Corporation 

XRD66092

ELECTRICAL CHARACTERISTICS TABLE (CONT’D)

Parameter

Symbol

Min

25°C

Typ

Max

Units Test Conditions/Comments

POWER SUPPLIES8

Operating Voltage (VDD)

VDD

Current (VDD)

IDD

AC PARAMETERS

5

V

35

45

mA

Signal Noise Ratio

SNR

66

dB

VIN = 5 Vp-p, 1 kHz

NOTES

1 Tester measures code transitions by dithering the voltage of the analog input (VIN). The difference between the measured and the

ideal code width (VREF/4096) is the DNL error. The INL error is the maximum distance (in LSBs) from the best fit line to

any transition voltage. Accuracy is a function of the sampling rate (FS).

2 Guaranteed. Not tested.

3 Specified values guarantee functionality. Refer to other parameters for accuracy.

4 –3 dB bandwidth is a measure of performance of the A/D input stage (S/H amplifier). Refer to other parameters for accuracy within

the specified bandwidth.

5 A 39Ω resistor should be put in series with VIN to dampen transients associated with inductive output impedance of typical op amps.

6 All inputs have diodes to VDD and GND. Input(s) MINV and LINV have internal pull down(s). Input DC currents will not exceed

specified limits for any input voltage between GND and VDD.

7 Condition to meet aperture delay specifications (tAP, tAJ). Actual rise/fall time can be less stringent with no loss of accuracy.

8 GND pins are internally connected through the silicon substrate.

Specifications are subject to change without notice

ABSOLUTE MAXIMUM RATINGS (TA = +25°C unless otherwise noted)1, 2, 3

VDD to GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 V

Storage Temperature . . . . . . . . . . . . . . –65 to +150°C

VRT & VRB . . . . . . . . . . . . . . . VDD +0.5 to GND –0.5 V

All Inputs . . . . . . . . . . . . . . . . VDD +0.5 to GND –0.5 V

Digital Outputs . . . . . . . . . . . VDD +0.5 to GND –0.5 V

Lead Temperature (Soldering 10 seconds) . . +300°C

Package Power Dissipation Rating @ 75°C

PDIP. SOIC . . . . . . . . . . . . . . . . . . . . . . . . . 1000mW

Derates above 75°C . . . . . . . . . . . . . . . . . 14mW/°C

NOTES:

1 Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a

stress rating only and functional operation at or above this specification is not implied. Exposure to maximum rating

conditions for extended periods may affect device reliability.

2 Any input pin which can see a value outside the absolute maximum ratings should be protected by Schottky diode clamps

(HP5082-2835) from input pin to the supplies. All inputs have protection diodes which will protect the device from short

transients outside the supplies of less than 100mA for less than 100µs.

3 GND refers to AGND and DGND.

Rev. 1.00

4

Share Link: