XE900 Просмотр технического описания (PDF) - Xecom
Номер в каталоге
Компоненты Описание
Список матч
XE900 Datasheet PDF : 16 Pages
| |||
FCC PART 15 REGULATIONS
Mounting the XE900SL10 in Your Assembly
The XE900SL10 must be mounted horizontally on your
printed circuit board to maintain proper orientation of
the transceiver. The XE900SL10 may not be co-located
with any other antenna or transmitter.
XE900SL10 Antenna
The XE900SL10 is certified for compliance to FCC Part
15 rules only using the Xecom XE900A10, 1/4 wave
monopole antenna. Use of any other antenna violates
FCC Part 15 rules.
FCC Part 15 Certification
The XE900SL10 has been certified per FCC Part 15 rules
for integration into OEM products without further
testing or certification. This certification is your
assurance that the XE900SL10 will not cause harmful
interference.
Labeling Requirements
FCC rules require the Original Equipment Manufacturer
using the XE900SL10 to place an appropriate label on
the outside of the finished equipment. The label must
be clearly visible and include the information shown
below.
Contains Transmitter Module
FCC ID: DWE-XE900SL10
WARNING:
This device complies with Part 15 of the FCC Rules.
Its operation is subject to the following conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any received interference
including interference that may cause undesired
operation.
Limitations
The XE900SL10 is registered under FCC Part 15 Rules.
To utilize this registration on your OEM System you
must follow the applications circuit provided in this
data sheet and use one of the listed antennas. Any
changes or modifications to the recommended circuit
must be approved by Xecom. Failure to seek Xecom’s
approval for modifications could void certification of
the end product.
Warning: RF Exposure
The XE900SL10 is approved for mobile, base station
applications. A minimum separation of 20 centimeters
should be maintained between the antenna and the
equipment operator. To ensure compliance, operation
at distances closer than those defined is not
recommended.
The Warning message below must be included in the
user Manual for the end product.
To comply with FCC RF exposure requirements
for mobile transmitting devices, this transmitter
should only be used or installed at locations where
there is at least 20 cm separation distance between
the antenna and all persons.
FCC Notifications
The XE900SL10 generates radio frequency energy. It
must be installed according to the manufacturer’s guide-
lines stated in the data sheet or it has the potential to
cause interference with other radio devices. Testing has
been performed to assure that it conforms with the FCC
Part 15 rules for intentional and unintentional radiators.
No further EMI compliance testing of the transmitter is
required as long as the 20 cm separation and co-location
requirements are observed. Each new use of the module
will, however, need to be scanned for unintentional ra-
diation from digital clocks, etc.
All necessary calibration has been performed at the time
of manufacture. Any modification of the device after it
leaves the factory is a violation of FCC rules.
XECOM
(15)
XE900SL10
Share Link: 