XE900 Просмотр технического описания (PDF) - Xecom
Номер в каталоге
Компоненты Описание
Список матч
XE900 Datasheet PDF : 16 Pages
| |||
XE900SL10 Configuration Registers
S 0 Answer Wireless Link Request: S0 determines if
the XE900SL10 will automatically respond to a
wireless link request.
S0=0 No Automatic response to link requests
S0=1 Automatically respond to link requests
S0=128
Automatically enter Broadcast mode on
power-up. Command must be stored in
nonvolatile memory using the AT&W
command.
S 2 Wireless Disconnect Character - S2 sets the ASCII
character to be used in the link disconnect sequence.
The default character is the tilde “~”.
Range: 0-255
Default: 126
S 7 Link Set-up Timer - S7 sets the length of time in
seconds that the transceiver will attempt to create a link
with the destination node.
Range: 0-60
Default: 10
S10 Link Recovery Timer - S10 sets the length of time in
seconds that the transceiver tries to recover a broken
link.
Range: 0-60
Default: 10
S12 Disconnect Guard Timer - S12 sets the guard timer
in milliseconds before and after the disconnect
sequence. If any characters other than the disconnect
sequence are received within the window defined by
S12 the disconnect request will be ignored.
Range: 0-255
Default: 20
Units: Milliseconds
S14 Bit-mapped Register - S14 stores the values of the ATE,
ATQ and ATV commands.
S23 Serial Interface Data rate - Set the serial data rate.
Range 1-10
1 = Set serial data rate to 1200 BPS
2 = Set serial data rate to 2400 BPS
3 = Set serial data rate to 4800 BPS
4 = Set serial data rate to 9600 BPS*
5 = Set serial data rate to 14400 BPS
6 = Set serial data rate to 19200 BPS
7 = Set serial data rate to 28800 BPS
8 = Set serial data rate to 38400 BPS
9 = Set serial data rate to 57600 BPS
10 = Set serial data rate to 115200 BPS
S39 Bit-mapped Register - S39 stores the value of the
AT&K command.
S104 Group ID Number - S104 sets the Group ID number.
Multiple groups may be active in the same area. Only
devices with the same group ID can communicate.
Range: 0-255
Default: 1
S105 XE900SL10 ID Number - S105 sets the node ID. Each
unit on the Network must have a unique ID number. The
ID number of the Master Node should always 1.
Range: 1-254
XECOM
(13)
XE900SL10
Share Link: 