AN-136 Просмотр технического описания (PDF) - Integrated Device Technology

Номер в каталоге

Компоненты Описание

Список матч

AN-136

A NEW GENERATION OF TAG SRAMS—THE IDT71215 AND IDT71216

Integrated Device Technology 

A NEW GENERATION OF TAG SRAMS—THE IDT71215 AND IDT71216

APPLICATION NOTE AN-136

Integrated Tag RAMs operate as ordinary SRAMs, but

have an additional access mode in which a word of data (an

index) is internally read (but not driven off-chip) and compared

with the CPU address driven onto the Tag RAM’s data bus.

Figure 2 shows the basic architecture of an integrated Tag

SRAM. The comparator indicates whether the cache holds

the data for the address supplied by the CPU or other bus

master. This is a critical timing path since this tag “hit” or “miss”

must be determined before the cache memory access can be

completed (or even started, in many cases). Note that tag

memories connect only to the CPU address bus and never to

the CPU data bus.

BASIC TAG RAM ARCHITECTURE

bit status memory on chip.

THE 71215 AND 71216

As shown in Figure 3, these 16K x 15 RAMs are configured

internally as two memories: 16K x 12 for tag and 16K x 3 for

status. These two memories share the address bus but are

controlled independently. An important new feature is extra

pins and logic for generating BRDY (Intel’s Burst Ready) and

TA (PowerPC’s Transfer Acknowledge). These are CPU input

signals which are time critical in zero wait state secondary

caches. I/O’s are 3.3V compatible and there is a low power

standby mode. All writes are synchronous as with burst data

SRAMs, while all reads and compares are asynchronous for

minimum delay. Two opposite polarity chip select pins are

provided for easy depth expansion.

WRITE

DATA

(TAG)

DATAIN

MEMORY

DATAOUT

ADDRESS

READ

COMPARE

MATCH

3176 drw 02

Figure 2. Basic Integrated Tag SRAM Architecture

An additional feature of the Tag SRAM is that a portion of

the memory is resettable. This permits use of one bit of the

data field as a “valid” status bit. Upon system initialization,

when the cache contains random data, a quick reset will clear

the valid bit for every cache line so that all initial cache

accesses will result in a miss. A miss then causes the address

to be loaded into the Tag RAM, data from main memory to be

loaded into the data RAMs, and the valid bit to be set true. If

not included in the Tag RAM, this function requires an addi-

tional 1-bit wide SRAM.

The reset feature of earlier Tag RAMs was sufficient for

implementation of a valid bit, but nothing more. Today’s

secondary caches frequently implement four-state write-back

protocols such as MESI, with multiprocessor applications

requiring five states (e.g. MOESI) or more. Hence, most

caches need a two- or three-bit status memory that is ac-

cessed separately from the tag memory. It is used in conjunc-

tion with the match output to determine the response to a CPU

memory access or a snoop. (A snoop is an operation initiated

by the system in order to maintain coherency between the

cache(s) and main memory.) This has typically been handled

with yet another RAM - a conventional separate I/O SRAM

organized as either x1 or x4. The 71215/16 includes a three-

2

Share Link: