ADJD-S312-CR999 Просмотр технического описания (PDF) - Avago Technologies
Номер в каталоге
Компоненты Описание
Список матч
ADJD-S312-CR999 Datasheet PDF : 18 Pages
| |||
Minimum sensitivity (note 13)
Parameter
Symbol
Saturation Irradiance
Conditions
lP = 460 nm
Refer Note 10
B
lP = 542 nm
Refer Note 11
G
lP = 645 nm
Refer Note 12
R
Minimum
Typical
(Note 3) Maximum Units
4.17
2.88
mWcm-2
1.90
Maximum sensitivity (note 13)
Parameter
Symbol
Saturation Irradiance
Conditions
lP = 460 nm
Refer Note 10
B
lP = 542 nm
Refer Note 11
G
lP = 645 nm
Refer Note 12
R
Minimum
Typical
(Note 3) Maximum Units
0.13
0.09
mWcm-2
0.06
Notes:
1. The “Absolute Maximum Ratings” are those values beyond which damage to the device may occur. The device should not be operated at these
limits. The parametric values defined in the “Electrical Specifications” table are not guaranteed at the absolute maximum ratings. The “Recom-
mended Operating Conditions” table will define the conditions for actual device operation.
2. Unless otherwise specified, all voltages are referenced to ground.
3. Specified at room temperature (25°C) and VDDD = VDDA = 2.6V.
4. Applies to all DI pins.
5. Applies to all DO pins. SDASLV go tri-state when output logic high. Minimum VOH depends on the pull-up resistor value.
6. Applies to all DO and DIO pins.
7. Dynamic testing is performed with the IC operating in a mode representative of typical operation.
8. Refers to total device current consumption.
9. Output and bidirectional pins are not loaded.
10. Test condition is blue light of peak wavelength (λP) 460 nm and spectral half width (∆λ½) 25 nm.
11. Test condition is green light of peak wavelength (λP) 542 nm and spectral half width (∆λ½) 35 nm
12. Test condition is red light of peak wavelength (λP) 645 nm and spectral half width (∆λ½) 20 nm
13. Saturation irradiance = (MSB)/(Irradiance responsivity)
Share Link: 