Overview
The ATtiny13 is a low-power CMOS 8-bit microcontroller based on the AVR enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the ATtiny13 achieves throughputs approaching 1 MIPS per MHz allowing the system designer to optimize power consumption versus processing speed.

FEATUREs
• High Performance, Low Power AVR® 8-Bit Microcontroller
• Advanced RISC Architecture
   – 120 Powerful Instructions – Most Single Clock Cycle Execution
   – 32 x 8 General Purpose Working Registers
   – Fully Static Operation
   – Up to 20 MIPS Througput at 20 MHz
• Non-volatile Program and Data Memories
   – 1K Byte of In-System Programmable Program Memory Flash Endurance: 10,000 Write/Erase Cycles
   – 64 Bytes In-System Programmable EEPROM Endurance: 100,000 Write/Erase Cycles
   – 64 Bytes Internal SRAM
   – Programming Lock for Self-Programming Flash Program and EEPROM Da Security
• Peripheral Features
   – One 8-bit Timer/Counter with Prescaler and Two PWM Channels
   – 4-channel, 10-bit ADC with Internal Voltage Reference
   – Programmable Watchdog Timer with Separate On-chip Oscillator
   – On-chip Analog Comparator
• Special Microcontroller Features
   – debugWIRE On-chip Debug System
   – In-System Programmable via SPI Port
   – External and Internal Interrupt Sources
   – Low Power Idle, ADC Noise Reduction, and Power-down Modes
   – Enhanced Power-on Reset Circuit
   – Programmable Brown-out Detection Circuit
   – Internal Calibrated Oscillator
• I/O and Packages
   – 8-pin PDIP/SOIC: Six Programmable I/O Lines
   – 20-pad MLF: Six Programmable I/O Lines
• Operating Voltage:
   – 1.8 - 5.5V for ATtiny13V
   – 2.7 - 5.5V for ATtiny13
• Speed Grade
   – ATtiny13V: 0 - 4 MHz @ 1.8 - 5.5V, 0 - 10 MHz @ 2.7 - 5.5V
   – ATtiny13: 0 - 10 MHz @ 2.7 - 5.5V, 0 - 20 MHz @ 4.5 - 5.5V
• Industrial Temperature Range
• Low Power Consumption
   – Active Mode:
      1 MHz, 1.8V: 240µA
   – Power-down Mode:
      < 0.1µA at 1.8V