T8200-HD Просмотр технического описания (PDF) - Amphenol Aerospace
Номер в каталоге
Компоненты Описание
Список матч
T8200-HD Datasheet PDF : 8 Pages
| |||
Ventostat Accessories
Enclosure Specifications
T1508 Aspiration Box for Duct Mounting
The Model 1508 is designed for in-duct sampling of
CO2 concentrations at flow rates greater than 400
fpm. Clear cover allows for observation of the sensor.
They will accommodate any of the Ventostat 8100
or 8200 series, and can be used for temperature and
RH when fitted. Enclosure is screwed to the duct with
probe inserted into air stream. Air sampling probe
is 1-inch (25.4mm) diameter and 8-inch (203.2mm)
long. Enclosure (ABS plastic) has knockouts for conduit
connection. Note: Wiring penetrations must be sealed
prior to use. CO2 sensor not included.
T1505 Splash Resistant Enclosure
The Model 1505 is designed to protect the 8000
series in damp or wet environments as might occur in
agricultural, industrial or food processing environments.
This enclosure (ABS plastic) is designed to protect the
sensor from dripping or sprayed water. Any wall mount
model of the Ventostat 8000 series sensor can be
installed inside the enclosure. The transparent cover
allows for viewing of the sensor/display. Four diffusion
ports allow for entry of CO2. Knockouts are provided
for conduit connection. Response time of the sensor is
slowed to approximately 30 minutes to measure a 90%
step change in concentrations. Enclosure is designed to
screw directly to a wall. CO2 sensor not included.
T1552 Outside Air Enclosure
The Model 1552 is a rugged weatherproof enclosure
(ABS plastic), designed to allow the 8000 series sensor
to operate in an outdoor environment and/or where
ambient temperatures are below freezing. The 1552 is
ideal for monitoring outside air or CO2 as a surrogate
for combustion fumes in parking garages, tunnels and
loading docks. This enclosure features a temperature
control circuit and internal heaters to maintain the
sensor within its normal operating temperature range,
even if temperatures outside the enclosure are as
low as -20°F (-29°C). Four diffusion ports allow for
entry of CO2. Response time of the sensor is slowed
to approximately 30 minutes to measure a 90% step
change in concentrations. Enclosure is designed to
screw directly to a wall. CO2 sensor not included. Power
consumption is 24V, 1.5 Amp (max), and includes the
Ventostat 8000 series.
T1508 Aspiration Box for Duct Mounting
T1505 Splash Resistant Enclosure and
T1552 Outside Air Enclosure
7
Share Link: 