PI5C3309 Просмотр технического описания (PDF) - Pericom Semiconductor Corporation

Номер в каталоге

Компоненты Описание

Список матч

PI5C3309

3:1 Mux/DeMux Bus Switch

Pericom Semiconductor Corporation 

PI5C3309

3:1 Mux/DeMux Bus Switch

Maximum Ratings

(Above which the useful life may be impaired. For user guidelines, not tested.)

Storage Temperature.......................................................... –65°C to +150°C

Ambient Temperature with Power Applied......................... –40°C to +85°C

Supply Voltage to Ground Potential (Inputs & VCC only) .. –0.5V to +7.0V

Supply Voltage to Ground Potential (Outputs & D/O only) .–0.5V to +7.0V

DC Input Voltage.................................................................. –0.5V to +7.0V

DC Output Current............................................................................ 120mA

Note:

Stresses greater than those listed under MAXIMUM RAT-

INGS may cause permanent damage to the device. This is

a stress rating only and functional operation of the device

at these or any other conditions above those indicated in

the operational sections of this specification is not implied.

Exposure to absolute maximum rating conditions for ex-

tended periods may affect reliability.

Power Dissipation..................................................................................0.5W

DC Electrical Characteristics (Over Operating Range, TA = –40°C to +85°C, VCC = 5V ±5%)

Parameters

Description

Test Conditions(1)

Min. Typ.(2)

VIH

Input HIGH Voltage

Guaranteed logic HIGH level

2.0

VIL

Input LOW Voltage

Guaranteed logic LOW level

–0.5

IIH

Input HIGH Current

VCC = Max., VIN = VCC

IIL

Input LOW Current

VCC = Max., VIN = GND

IOZH High Impedance Output Current 0 ≤ IN, YN ≤ VCC

VIK

Clamp Diode Voltage

VCC = Min, IIN = -18mA

–0.7

IOS

Short Circuit current

I(Y)=0V, Y(I)=VCC

VH

Input Hysteresis at Control Pins

150

RON

Switch on Resistance (4)

VCC = Min., VIN = 0.0V, ION = 48mA

VCC = Min., VIN = 2.4V, ION = 15mA

5

10

Notes:

1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.

2. Typical values are at VCC = 5.0V, TA = 25°C ambient and maximum loading.

3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.

4. Measured by the voltage drop between I and Y pin at indicated current through the switch. On-Resistance is determined

by the lower of the voltages on the two (I, Y) pins.

Max.

0.8

±1

±1

±1

1.2

100

7

15

Units

V

µA

V

mA

mV

Ω

Capacitance (TA = 25°C, f = 1 MHz)

Parameters(1)

Description

Test Conditions

CIN

COFF

CON

Input Capacitance

IA Capacitance, Switch Off

IA Capacitance, Switch On

VIN = 0V

Notes:

1. This parameter is determined by device characterization but is not production tested.

Typ.

3

4

16

Units

pF

12-0242

2

www.pericom.com

P-0.1

08/03/12

Share Link: