HMC7992 Просмотр технического описания (PDF) - Analog Devices
Номер в каталоге
Компоненты Описание
Список матч
HMC7992 Datasheet PDF : 13 Pages
| |||
Data Sheet
THEORY OF OPERATION
The HMC7992 requires a single positive supply voltage applied
to the VDD pin. A bypassing capacitor is recommended on the
supply line to minimize RF coupling.
The HMC7992 integrates with an internal 2:4 decoder; the four
RF paths are selected via the two digital control voltages applied
to the A and B control inputs. A small value bypassing capacitor
is recommended on these digital signal lines to improve the RF
signal isolation.
The HMC7992 is internally matched to 50 Ω at the RF common
port (RFC) and the RF ports (RF1, RF2, RF3, and RF4); therefore,
no external matching components are required. The RF pins are
dc-coupled and dc blocking capacitors are required on the RF
paths. The design is bidirectional; the RF input signals can apply
at the RFC port or the RF1 to RF4 ports. The inputs and outputs
are interchangeable.
HMC7992
Depending on the logic level applied to the control input pins,
A and B, one RF output port (for example, RF1) is set to on
mode, by which an insertion loss path is provided from the
input to the output. The other RF output ports (for example,
RF2, RF3, and RF4) are then set to off mode, by which the
outputs are isolated from the input. When the RF output ports
(RF1, RF2, RF3, and RF4) are in isolation mode, they are
internally terminated to 50 Ω, and thereby can absorb the
applied RF signal.
The ideal power-up sequence is as follows:
1. Power up GND.
2. Power up VDD.
3. Power up the digital control inputs. The relative order of
the logic control inputs is not important. Powering the
logic control inputs before the VDD supply can inadvertently
forward bias and damage the internal ESD protection
structures.
4. Apply the RF input.
Table 7. Switch Mode Operation
Digital Control Inputs Signal Mode
A
B
RFC to RFx
Low
Low
RF Port 1 is in on mode, providing a low insertion loss path from the RFC port to the RF1 port. The remaining RF
ports (RF2, RF3, and RF4) are in off mode; they are isolated from the RFC port and internally terminated to a 50 Ω load.
High Low
RF Port 2 is in on mode, providing a low insertion loss path from the RFC port to the RF2 port. The remaining RF
ports (RF1, RF3, and RF4) are in off mode; they are isolated from the RFC port and internally terminated to a 50 Ω load.
Low
High
RF Port 3 is in on mode, providing a low insertion loss path from the RFC port to the RF3 port. The remaining RF
ports (RF1, RF2, and RF4) are in off mode; they are isolated from the RFC port and internally terminated to a 50 Ω load.
High High
RF Port 4 is in on mode, providing a low insertion loss path from the RFC port to the RF4 port. The remaining RF
ports (RF1, RF2, and RF3) are in off mode; they are isolated from the RFC port and internally terminated to a 50 Ω load.
Rev. 0 | Page 11 of 13
Share Link: 