LH543620P-20 Просмотр технического описания (PDF) - Sharp Electronics
Номер в каталоге
Компоненты Описание
Список матч
LH543620P-20 Datasheet PDF : 38 Pages
| |||
LH543620
1024 × 36 Synchronous FIFO
ABSOLUTE MAXIMUM RATINGS 1
PARAMETER
RATING
Supply Voltage to VSS Potential
Signal Pin Voltage to VSS Potential 2
DC Output Current 3
Storage Temperature Range
–0.5 V to 7 V
–0.5 V to VCC + 0.5 V
± 75 mA
–65oC to 150oC
Power Dissipation (Package Limit)
2.5 Watts (Quad Flat Pack)
NOTES:
1. Stresses greater than those listed under ‘Absolute Maximum Ratings’ may cause permanent damage to the device. This is a stress rating for
transient conditions only. Functional operation of the device at these or any other conditions outside those indicated in the ‘Operating Range’
of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability.
2. Negative undershoot of 1.5 V in amplitude is permitted for up to 10 ns, once per cycle.
3. Outputs should not be shorted for more than 30 seconds. No more than one output should be shorted at any time.
OPERATING RANGE
SYMBOL
PARAMETER
MIN
MAX
UNIT
TA
Temperature, Ambient
0
70
oC
VCC
Supply Voltage
4.5
5.5
V
VSS
Supply Voltage
0
0
V
VIL
Logic LOW Input Voltage 1 –0.5
0.8
V
VIH
Logic HIGH Input Voltage 2.2 Vcc + 0.5 V
NOTE:
1. Negative undershoot of 1.5 V in amplitude is permitted for up to 10 ns, once per cycle.
DC ELECTRICAL CHARACTERISTICS (Over Operating Range)
SYMBOL
PARAMETER
TEST CONDITIONS
MIN
TYP
ILI
Input Leakage Current
VCC = 5.5 V, VIN = 0 V To VCC
–10
ILO
I/O Leakage Current
OE ≥ VIH, 0 V ≤ VOUT ≤ VCC
–10
VOL
Logic LOW Output Voltage
IOL = 16.0 mA
VOH
Logic HIGH Output Voltage
IOH = –8.0 mA
2.4
ICC
Average Supply Current 1,2
Measured at fC = maximum
205
ICC2
Average Standby Supply Current 1,3 All Inputs = VIHMIN (Clock idle)
40
ICC3
Power-Down Supply Current 1
All Inputs = VCC,
Outputs – open,
Control – deasserted,
Clocks = VCC
0.01
NOTE:
1. ICC, ICC2, and ICC3 are dependent upon actual output loading, and ICC is also dependent on cycle times.
Specified values are with outputs open (for ICC: CL = 0 pF); and, for ICC, operating at minimum cycle times.
2. ICC (MAX): Using worst case conditions and data pattern. ICC (TYP): Using VCC = 5 V and average data pattern.
3. ICC2 (TYP): Using VCC = 5 V and TA = 25°C.
MAX
10
10
0.4
380
85
1.0
UNIT
µA
µA
V
V
mA
mA
mA
6
Share Link: 