MIKROE-1200 Просмотр технического описания (PDF) - Unspecified

Номер в каталоге

Компоненты Описание

Список матч

MIKROE-1200

EEPROM Click™ Board

Unspecified 

EEPROM click

1. Introduction

EEPROM Click™ is an accessory board in

mikroBUS™ form factor. It’s a compact

and easy solution for adding more EEPROM

memory to your device. It features DIP

24C08 8kbit serial EEPROM module in DIP 8

socket. EEPROM Click™ communicates with

target board via I2C interface. The board is

designed to use 3.3V and 5V power supply.

It has a LED diode (GREEN) that indicates the

presence of power supply.

2. Soldering the headers

Before using your click board™, make sure

to solder 1x8 male headers to both left

and right side of the board. Two 1x8 male

headers are included with the board in

the package.

1

2

Turn the board upside down so that

bottom side is facing you upwards. Place

shorter parts of the header pins in both

soldering pad locations.

3

Turn the board upward again. Make sure

to align the headers so that they are

perpendicular to the board, then solder the

pins carefully.

4. Essential features

EEPROM Click™ with it’s DIP 24C08 module

gives additional 8kbit EEPROM memory to

your design. The 24C08 module supports

both the 100kHz I2C standard-mode and the

400kHz I2C fast-mode. It has write control

input, byte or page write (up to 16 bytes),

random and sequential read modes and

automatic address incrementing. You can put

other EEPROM chip with different capacity in

DIP8 socket.

3. Plugging the board in

Once you have soldered the headers your

board is ready to be placed into desired

mikroBUS™ socket. Make sure to align the

cut in the lower-right part of the board

with the markings on the silkscreen at the

mikroBUS™ socket. If all of the pins are

aligned correctly, push the board all

the way into the socket.

click

BOARD

www.mikroe.com

EEPROM click Manual

ver. 1.00

0 100000 021064

Share Link: