M48T128V(2010) Просмотр технического описания (PDF) - STMicroelectronics

Номер в каталоге

Компоненты Описание

Список матч

M48T128V
(Rev.:2010)

5.0 or 3.3 V, 1 Mbit (128 Kb x 8) TIMEKEEPER® SRAM

STMicroelectronics 

M48T128Y, M48T128V

3

Clock operations

Clock operations

3.1

Reading the clock

Updates to the TIMEKEEPER® registers should be halted before clock data is read to

prevent reading data in transition. The BiPORT™ TIMEKEEPER cells in the RAM array are

only data registers and not the actual clock counters, so updating the registers can be halted

without disturbing the clock itself.

Updating is halted when a '1' is written to the READ bit, D6 in the control register (1FFF8h).

As long as a '1' remains in that position, updating is halted. After a halt is issued, the

registers reflect the count; that is, the day, date, and time that were current at the moment

the halt command was issued. All of the TIMEKEEPER registers are updated

simultaneously. A halt will not interrupt an update in progress. Updating is within a second

after the bit is reset to a '0.'

3.2

Setting the clock

Bit D7 of the control register (1FFF8h) is the WRITE bit. Setting the WRITE bit to a '1,' like

the READ bit, halts updates to the TIMEKEEPER registers. The user can then load them

with the correct day, date, and time data in 24-hour BCD format (see Table 5 on page 12).

Resetting the WRITE bit to a '0' then transfers the values of all time registers 1FFFFh-

1FFF9h to the actual TIMEKEEPER counters and allows normal operation to resume. After

the WRITE bit is reset, the next clock update will occur one second later.

3.3

Stopping and starting the oscillator

The oscillator may be stopped at any time. If the device is going to spend a significant

amount of time on the shelf, the oscillator can be turned off to minimize current drain on the

battery. The STOP bit is located at bit D7 within 1FFF9h. Setting it to a '1' stops the

oscillator. The M48T128Y/V is shipped from STMicroelectronics with the STOP bit set to a

'1.' When reset to a '0,' the M48T128Y/V oscillator starts after one second.

Doc ID 5746 Rev 6

11/23

Share Link: