M65761FP
(4) Read out/write in sequence of context table RAM
This sequence dies R/W of context table RAM.
Set context mode
d7
d0
; H/W reset bit OFF
SYS_REG: − − − − C − − 0 ; C = Context mode set
Start command for R/W
of RAM
CMD_REG: 0 0 0 0 0 1 0 0 ; Start of R/W context table RAM
[Reading (writing) of context table RAM continues during this time.]
RAM data is outputted (inputted) by way of data read (write) buffer.
The RAM address is automatically incremented every time 1 byte is read out (write in).
Note: It is not possible to mix reading and writing.
End of R/W command of RAM
CMD_REG: 0 0 0 0 0 0 0 0 ; End of R/W command of RAM
Note: The assignment of address for context table RAM is as follows
This does not end automatically.
Be sure to write the end of R/W command.
Internal context mode: Address 0 to 1023 of (LSB: 0, MSB: 9) as shown below.
External context mode: Address 0 to 4095 of (LSB: CX0, MSB: CS11)
876
54329
10?
3-line template
854329
7610?
2-line template
(AT pixel is MSB: 9)
REJ03F0234-0200 Rev.2.00 Sep 14, 2007
Page 21 of 33