W66910CD Просмотр технического описания (PDF) - Winbond

Номер в каталоге

Компоненты Описание

производитель

W66910CD

TE Mode ISDN S/T-Controller with Microprocessor Interface

Winbond 

Data Sheet

7.2 Layer 1 Functions Descriptions

W66910 PCI ISDN S/T-Controller

The layer 1 functions includes :

- Transmitter/Receiver which conform to the electrical specifications of ITU-T I.430

- Receiver clock recovery and timing generation

- Output phase delay (deviation) compensation

- Layer 1 activation/deactivation procedures

- D channel access control

- Frame alignment

- Multi-frame synchronization

- Test functions

7.2.1 S/T Interface Transmitter/Receiver

According to ITU-T I.430, pseudo-ternary code with 100% pulse width is used in both directions of transmission on the S/T

interface. The binary "1" is represented by no line signal (zero volt), whereas a binary "0" is represented by a positive or negative

pulse.

Data transmissions on the S/T interface are arranged as frame structures. The frame is 250 µs long and consists of 48 bits, which

corresponds to a 192 kbit/s line rate. Each frame carries two octets of B1 channel, two octets of B2 channel and four D channel

bits. Therefore, the 2B+D data rate is 144 kbit/s. The frame structure is shown in Fig.7.1.

The frame begin is marked by a framing bit, which is followed by a DC balancing bit. The first binary "0" following the framing

bit balancing bit is of the same polarity as the framing bit balancing bit, and subsequent binary zeros must alternate in polarity.

-16 -

Publication Release Date: Feb,2001

Revision 1.0

Share Link: