VE-BAMD Просмотр технического описания (PDF) - Vicor

Номер в каталоге

Компоненты Описание

Список матч

VE-BAMD

High-Boost Harmonic Attenuation Module

Vicor 

PIN FUNCTION / DESCRIPTION (CONT.)

P/OK

Power OK is a monitor signal that indicates the status of the

AC mains and the DC output voltage of the HAM. P/OK is

asserted (active low) when the output bus voltage is within

normal operating range (>270 Vdc) and 20 – 25 ms after DC-DC

converters are enabled by the E/O signal of the HAM. This

provides sufficient time for the converters to turn on and their

output(s) to stabilize prior to P/OK being asserted, (Figure 9).

For momentary interruptions of AC power, the HAM will

provide at least 16 ms of ride through or hold up time (with

1,000 µF output capacitor). On loss of power or brownout,

(when the HAM output voltage drops below 270 Vdc) the

P/OK signal will go to an open circuit state (Figure 7),

signaling an impending loss of input power to the converter

modules. P/OK will provide power fail warning at least 1 ms

prior to converter shut down. When the HAM output voltage

drops below 250 Vdc the converters are disabled via Enable

Output (E/O).

LOGIC

D

G

S

+OUT

P/OK

E/O

A/S

–OUT

Figure 7 — Power OK (P/OK)

LOGIC

+OUT

P/OK

E/O

D

A/S

G S –OUT

Figure 8 — Enable / Output (E/O)

AC Mains

120 Vrms

DC Output

of HAM

280 Vdc

Boost Voltage

Rectified Line

Enable Output (E/O)

270 Vdc

250 Vdc

Off at 250 Vdc

Power OK (P/OK)

25 ms

Off at 270 Vdc

Outputs

DC-DC Converter(s)

10 ms

Off below 250 Vdc

Figure 9 — Start up / shut down timing diagram

Vicor Corp. Tel: 800-735-6200, 978-470-2900 Fax: 978-475-6715 HAM, High-Boost Harmonic Attenuation Module

Set your site on VICOR at vicorpower.com

Rev. 2.5

Page 7 of 10

Share Link: