VM6101 Просмотр технического описания (PDF) - STMicroelectronics

Номер в каталоге

Компоненты Описание

производитель

VM6101

I²C color light sensor

STMicroelectronics 

Functional description

VM6101

Table 2. Threshold module configurations (TH_CFG register usage)

EN_HI:

EN_LO

INT output

INT versus CNT

(assumes INT_POL = 0)

00

0

01

POL_LO xor (CNT < TH_LO)

0

1

0

TH_LO TH_HI

(POL_LO = 0)

10

POL_HI xor (CNT < TH_HI)

11

HYST = 0:

(POL_LO xor (CNT < TH_LO)) and

(POL_HI xor (CNT < TH_HI))

HYST = 1: see diagram

1

0

(POL_HI = 0)

TH_LO TH_HI

1

0

TH_LO TH_HI

(POL_LO = 1, POL_HI = 0)

1

0

TH_LO TH_HI

(POL_LO = 1, POL_HI = 0)

Notes

1. Upon reset, the comparator logic is enabled (EN_HI:EN_LO = 01) with POL_LO = 1 and TH_LO = 0x0008.

The INT pin is high when Y channel count > 8.

2. Assuming CONTROL= 0x04, i.e. comparator mode using Y channel count (default value for CONTROL

register).

3. Ensure TH_LO < TH_HI otherwise unpredictable results may occur.

2.3

PWM generator

The pulse width modulator (PWM) generates a signal which may be used to directly control

LCD backlight driver ICs according to ambient light level.

There are three registers to control the PWM generator operation:

● PWM_FREQ register bits [4:0] sets the period of the PWM signal. This is adjustable

from 12Hz to 400kHz.

● PWM_SENS register bits [4:0] sets the sensitivity of the PWM signal to light level.

● CONTROL register bit 2 = 0 to select PWM output at INT pin.

● CONTROL register bit 3 controls the polarity of the PWM output (default = 0).

For more details please refer to Chapter 4: Register description.

The curve below shows typical PWM output duty cycle (default polarity) as a function of

illumination, with sensitivity setting ranging from 9 to 18, corresponding to typical use cases

(10 to 10000 lx illumination).

6/17

Share Link: