PCA9548A Просмотр технического описания (PDF) - NXP Semiconductors.

Номер в каталоге

Компоненты Описание

Список матч

PCA9548A

8-channel I2C-bus switch with reset

NXP Semiconductors. 

NXP Semiconductors

PCA9548A

8-channel I2C-bus switch with reset

7. Characteristics of the I2C-bus

The I2C-bus is for 2-way, 2-line communication between different ICs or modules. The two

lines are a serial data line (SDA) and a serial clock line (SCL). Both lines must be

connected to a positive supply via a pull-up resistor when connected to the output stages

of a device. Data transfer may be initiated only when the bus is not busy.

7.1 Bit transfer

One data bit is transferred during each clock pulse. The data on the SDA line must remain

stable during the HIGH period of the clock pulse as changes in the data line at this time

will be interpreted as control signals (see Figure 8).

SDA

SCL

Fig 8. Bit transfer

data line

stable;

data valid

change

of data

allowed

mba607

7.2 START and STOP conditions

Both data and clock lines remain HIGH when the bus is not busy. A HIGH-to-LOW

transition of the data line while the clock is HIGH is defined as the START condition (S). A

LOW-to-HIGH transition of the data line while the clock is HIGH is defined as the STOP

condition (P) (see Figure 9).

SDA

SCL

S

START condition

Fig 9. Definition of START and STOP conditions

P

STOP condition

mba608

7.3 System configuration

A device generating a message is a ‘transmitter’, a device receiving is the ‘receiver’. The

device that controls the message is the ‘master’ and the devices which are controlled by

the master are the ‘slaves’ (see Figure 10).

PCA9548A

Product data sheet

All information provided in this document is subject to legal disclaimers.

Rev. 5.1 — 1 October 2015

© NXP B.V. 2015. All rights reserved.

9 of 30

Share Link: