MB90598 Просмотр технического описания (PDF) - Fujitsu

Номер в каталоге

Компоненты Описание

Список матч

MB90598

16-bit Proprietary Microcontroller

Fujitsu 

MB90595/595G Series

(Continued)

Features

MB90598/598G

MB90F598/F598G MB90V595/V595G

CAN Interface

Number of channels: 1

Conforms to CAN Specification Version 2.0 Part A and B

Automatic re-transmission in case of error

Automatic transmission responding to Remote Frame

Prioritized 16 message buffers for data and ID’s

Supports multiple messages

Flexible configuration of acceptance filtering:

Full bit compare / Full bit mask / Two partial bit masks

Supports up to 1Mbps

CAN bit timing setting:

MB90xxx:TSEG2 ≥ RSJW+2TQ

MB90xxxG:TSEG2 ≥ RSJW

Stepping motor controller Four high current outputs for each channel

(4 channels)

Synchronized two 8-bit PWM’s for each channel

External interrupt circuit

Number of inputs: 8

Started by a rising edge, a falling edge, an “H” level input, or an “L” level input.

Serial IO

Clock synchronized transmission (31.25 K/62.5 K/125 K/500 K/1 Mbps at system clock

frequency of 16 MHz)

LSB first/MSB first

Watchdog timer

Reset generation interval: 3.58 ms, 14.33 ms, 57.23 ms, 458.75 ms

(at oscillation of 4 MHz, minimum value)

Flash Memory

Supports automatic programming, Embedded Algorithm TM and

Write/Erase/Erase-Suspend/Resume commands

A flag indicating completion of the algorithm

Hard-wired reset vector available in order to point to a fixed boot sector in Flash

Memory

Boot block configuration

Erase can be performed on each block

Block protection with external programming voltage

Flash Writer from Minato Electronics Inc.

Low-power consumption

(stand-by) mode

Sleep/stop/CPU intermittent operation/clock timer/hardware stand-by

Process

CMOS

Power supply voltage for

operation*2

+5 V±10 %

Package

QFP-100

PGA-256

*1: It is setting of DIP switch S2 when Emulation pod (MB2145-507) is used.

Please refer to the MB2145-507 hardware manual (2.7 Emulator-specific Power Pin) about details.

*2: Varies with conditions such as the operating frequency. (See section “s ELECTRICAL CARACTERISTICS.”)

5

Share Link: