LT3980IMSE-TRPBF Просмотр технического описания (PDF) - Linear Technology

Номер в каталоге

Компоненты Описание

Список матч

LT3980IMSE-TRPBF

58V, 2A, 2.4MHz Step-Down Switching Regulator with 85µA Quiescent Current

Linear Technology 

LT3980

Pin Functions (DFN, MSOP)

SYNC (Pin 1/Pin 1): This is the external clock synchro-

nization input. Ground this pin for low ripple Burst Mode

operation at low output loads. Tie to a voltage above 0.8V

to select pulse-skipping mode. Tie to a clock source for

synchronization. Clock edges should have rise and fall

times faster than 1µs. Tie pin to GND if not used. See the

Synchronization section in Applications Information.

NC (Pins 2, 13/Pins 3, 5, 13, 16): No Connect. These

pins are not connected to internal circuitry.

PG (Pin 3/Pin 2): The PG pin is the open collector output

of an internal comparator. PG remains low until the FB pin

is within 9% of the final regulation voltage. PG output is

valid when VIN is above 3.6V and RUN/SS is high.

FB (Pin 4/Pin 4): The LT3980 regulates the FB pin to 0.790V.

Connect the feedback resistor divider tap to this pin.

VC (Pin 5/Pin 6): The VC pin is the output of the internal

error amplifier. The voltage on this pin controls the peak

switch current. Tie an RC network from this pin to ground

to compensate the control loop.

RT (Pin 6/Pin 7): Oscillator Resistor Input. Connecting

a resistor to ground from this pin sets the switching

frequency.

GND (Pin 7, 15/Pin 8, 17): Ground. The exposed pads

must be soldered to the PCB.

RUN/SS (Pin 8/Pin 9): The RUN/SS pin is used to put the

LT3980 in shutdown mode. Tie to ground to shut down

the LT3980. Tie to 2.5V or more for normal operation. If

the shutdown feature is not used, tie this pin to the VIN

pin. RUN/SS also provides a soft-start function; see the

Applications Information section.

BD (Pin 9/Pin 10): This pin connects to the anode of the

boost Schottky diode. BD also supplies current to the

internal regulator.

BOOST (Pin 10/Pin 11): This pin is used to provide a drive

voltage, higher than the input voltage, to the internal bipolar

NPN power switch.

SW (Pin 11/Pin 12): The SW pin is the output of the

internal power switch. Connect this pin to the inductor,

catch diode and boost capacitor.

VIN (Pin 12/Pin 14): The VIN pin supplies current to the

LT3980’s internal regulator and to the internal power switch.

This pin must be locally bypassed.

DA (Pin 14/Pin 15): This pin measures catch diode current

and pauses the oscillator during overcurrent conditions.

Block Diagram

VIN

VIN

C1

INTERNAL 0.79V REF

RUN/SS

–

+

Σ

SLOPE COMP

RT

RT

SYNC

SOFT-START

PG

GND

ERROR AMP

0.725V

+

–

FB

R2

R1

OSCILLATOR

100kHzTO2.4MHz

SWITCH

LATCH

R

Q

S

DISABLE

BurstMode

DETECT

VC CLAMP

For more information www.linear.com/LT3980

BD

BOOST

SW

DA

C3

L1

D1

VOUT

C2

VC

CC

RC

CF

3680 BD

3980fa

7

Share Link: