LT3512 Просмотр технического описания (PDF) - Linear Technology

Номер в каталоге

Компоненты Описание

Список матч

LT3512

Monolithic High Voltage Isolated Flyback Converter

Linear Technology 

LT3512

PIN FUNCTIONS

EN/UVLO (Pin 1): Enable/Undervoltage Lockout. The EN/

UVLO pin is used to start up the LT3512. Pull the pin to 0V

to shut down the LT3512. This pin has an accurate 1.21V

threshold and can be used to program an undervoltage

lockout (UVLO) threshold using a resistor divider from

supply to ground. A 2.6μA pin current hysteresis allows

the programming of undervoltage lockout (UVLO) hys-

teresis. EN/UVLO can be directly connected to VIN. If left

open circuit the part will not power up.

VIN (Pin 3): Input Supply Pin. This pin supplies current to

the internal start-up circuitry, and serves as a reference

voltage for the DCM comparator and feedback circuitry.

Must be locally bypassed with a capacitor.

GND (Pin 5, 8, 9): Ground Pins. All three pins should be

tied directly to the local ground plane.

BIAS (Pin 6): Bias Voltage. This pin supplies current to

the switch driver and internal circuitry of the LT3512.

This pin may also be connected to VIN if a third winding

is not used and if VIN < 20V. The part can operate down

to 4.5V when BIAS and VIN are connected together. If a

third winding is used, the BIAS voltage should be lower

than the input voltage and greater than 3.3V for proper

operation. BIAS must be bypassed with a 4.7μF capacitor

placed close to the pin.

VC (Pin 10): Compensation Pin for Internal Error Amplifier.

Connect a series RC from this pin to ground to compensate

the switching regulator. An additional 100pF capacitor from

this pin to ground helps eliminate noise.

TC (Pin 11): Output Voltage Temperature Compensa-

tion. Connect a resistor to ground to produce a current

proportional to absolute temperature to be sourced into

the RREF node.

ITC = 0.55V/RTC.

RREF (Pin 12): Input Pin for External Ground-Referred

Reference Resistor. The resistor at this pin should be 10k.

For nonisolated applications, a traditional resistor voltage

divider from VOUT may be connected to this pin.

RFB (Pin 14): Input Pin for External Feedback Resistor.

This pin is connected to the transformer primary (VSW).

The ratio of this resistor to the RREF resistor, times the

internal bandgap reference, determines the output volt-

age (plus the effect of any non-unity transformer turns

ratio). For nonisolated applications, this pin should be

connected to VIN.

SW (Pin 16): Switch Pin. Collector of the internal power

switch. Minimize trace area at this pin to minimize EMI

and voltage spikes.

3512f

5

Share Link: