FM31278-G(2011) Просмотр технического описания (PDF) - Ramtron International Corporation
Номер в каталоге
Компоненты Описание
Список матч
FM31278-G Datasheet PDF : 26 Pages
| |||
FM31278/276/274/272 - 5V I2C Companion
A1, A0
SCL
SDA
2-Wire
Interface
LockOut
F-RAM
Array
LockOut
RST
PFI
CAL/PFO
VDD
2.5V -
+
VBAK
Watchdog
LV Detect
Special
Function
Registers
S/N
+
- 1.2V
RTC Cal.
512Hz
Switched Power
RTC Registers
RTC
Event
Counters
X1
X2
CNT1
CNT2
Nonvolatile
Battery Backed
Figure 1. Block Diagram
Pin Descriptions
Pin Name
A0, A1
Type
Input
CNT1,
CNT2
CAL/PFO
X1, X2
/RST
SDA
Input
Output
I/O
I/O
I/O
SCL
PFI
VBAK
VDD
VSS
Input
Input
Supply
Supply
Supply
Pin Description
Device select inputs are used to address multiple memories on a serial bus. To select the
device the address value on the two pins must match the corresponding bits contained in
the device address. The device select pins are pulled down internally.
Event Counter Inputs: These battery-backed inputs increment counters when an edge is
detected on the corresponding CNT pin. The polarity is programmable. These pins
should not be left floating. Tie to ground if these pins are not used.
In calibration mode, this pin supplies a 512 Hz square-wave output for clock calibration.
In normal operation, this is the early power-fail output.
32.768 kHz crystal connection. When using an external oscillator, apply the clock to X1
and a DC mid-level to X2 (see Crystal Oscillator section for suggestions).
Active low reset output with weak pull-up. Also input for manual reset.
Serial Data & Address: This is a bi-directional line for the two-wire interface. It is open-
drain and is intended to be wire-OR‟d with other devices on the two-wire bus. The input
buffer incorporates a Schmitt trigger for noise immunity and the output driver includes
slope control for falling edges. A pull-up resistor is required.
Serial Clock: The serial clock line for the two-wire interface. Data is clocked out of the
part on the falling edge, and in on the rising edge. The SCL input also incorporates a
Schmitt trigger input for noise immunity.
Early Power-fail Input: Typically connected to an unregulated power supply to detect an
early power failure. This pin should not be left floating.
Backup supply voltage: A 3V battery or a large value capacitor. If no backup supply is
used, this pin should be tied to ground and the VBC bit should be cleared. The trickle
charger is UL recognized and ensures no excessive current when using a lithium battery.
Supply Voltage
Ground
Rev. 2.1
Sept. 2011
Page 3 of 26
Share Link: 