DF14-10P-1.25H55 Просмотр технического описания (PDF) - HIROSE ELECTRIC

Номер в каталоге

Компоненты Описание

Список матч

DF14-10P-1.25H55

1.25mm Pitch Super Low profile Crimping Connector

HIROSE ELECTRIC 

The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.

All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the HDirFos1e4weSbesirteieRsoHqS1se.2ar5cmh amt wwPwi.thcirhoseS-cuopnneerctoLros.cwomp, roor cfoilnetacCt ryiomurpHiinrogseCsaolensnreepcretsoenrtative.

BPrecautions

1. Recommended Temperature Profile (SMT)

Temperature

250ç

200ç

150ç

100ç

Max. 240

220

60 to 120s

Preheating

10s max.

60s max.

Soldering

IR reflow condition

Preheating area 150ç for 60 to 120 seconds

Soldering area 250 for 10 seconds max.

220ç min. 60 seconds max.

Time

2. Recommended Manual Soldering Condition (SMT)

3. Recommended Screen Thickness (SMT)

4. Board Sled (SMT)

5. Cleaning Condition

6. Connection Condition

7. Precautions

8. Cautions

Note 1.Up to 2 cycles of Reflow soldering are possible under the same conditions, provided

that there is a return to normal temperature between the first and second cycle.

Note 2.The temperature profile indicates the board surface temperature at the point of

contacts with the connector terminals.

Manual soldering: 290ç for 2 seconds

0.15 to 0.2mm

Max 0.03mm at the connector center area, based on both connector edges

Refer to Nylon Connector Use Hand book.

Refer to Nylon Connector Use Hand book.

sBe careful to carry out the crimping operation according to the "Crimping Condition Sheet"

and "Crimping Quality Reference", because the crimping contact style is too small.

Refer to Nylon Connector Use Hand book.

sBe careful for an excessive scoop insertion/extraction, which will cause damage to the

product.

BPrecautions

Precautions at Time of Insertion

Precautions at Time of Disconnection

Handling

Method: Lightly grasping the base of the cable, press the

connector with your finger and insert it.

Handling

Method: Grasp the cable so that the entire cable is pulled

evenly and pull it out.

Insertion Angle

[Caution] Do not insert at an angle of 30° or greater. Doing so

will cause contact deformation or case damage.

Method: Insert with the connector parallel.

Angle of Removal

[Caution] Do not remove at an angle of 30° or greater. Doing so

will cause contact deformation or case damage.

Method: Remove with the connector parallel.

Parallel

Diagonal

Parallel

Diagonal

Parallel

Diagonal

Parallel

Diagonal

B241

Share Link: