CS5181-BL Просмотр технического описания (PDF) - Cirrus Logic

Номер в каталоге

Компоненты Описание

Список матч

CS5181-BL

∆Σ Modulator & 400 kHz to 625 kHz 16-Bit ADC

Cirrus Logic 

CS5181

GENERAL DESCRIPTION

The CS5181 is a monolithic CMOS 16-bit A/D

converter designed to operate in continuous mode

after being reset.

The CS5181 can operate in modulator-only mode

in which the bit stream from the modulator is the

data output from the device.

THEORY OF OPERATION

The front page of this data sheet illustrates the

block diagram of the CS5181.

Converter Initialization: Calibration and

Synchronization

The CS5181 does not have an internal power-on re-

set circuit. Therefore when power is first applied to

the device the RESET pin should be held low until

power is established. This resets the converter’s log-

ic to a known state. When power is fully established

the converter will perform a self-calibration, starting

with the first MCLK rising edge after RESET goes

high. The converter will use 988,205 MCLK cycles

to complete the calibration and to allow the digital

filter to fully settle, after which, it will output fully-

settled conversion words. The converter will then

continue to output conversion words at an output

word rate equal to MCLK/64. Figure 2 illustrates

the RESET and SYNC logic and timing for the con-

verter.

The CS5181 is designed to perform conversions

continuously with an output rate that is equivalent

to MCLK/64. The conversions are performed and

the serial port is updated independent of external

controls. The converter is designed to measure dif-

ferential bipolar input signals, and unipolar signals,

with a common mode voltage of between 1.0 V and

VREF + 0.25 V. Calibration is performed when the

RESET signal to the device is released. If RESET

is properly framed to MCLK, the converter can be

synchronized to a specific MCLK cycle at the sys-

tem level.

The SYNC signal can also be used to synchronize

multiple converters in a system. When SYNC is

used, the converter does not perform calibration.

The SYNC signal is recognized on the first rising

edge of MCLK after SYNC goes high. SYNC

aligns the output conversion to occur every 64

MCLK clock cycles after the SYNC signal is rec-

ognized and the filter is settled. After the SYNC is

initiated by going high, the converter will wait

5,161 MCLK cycles for the digital filter to settle

before putting out a fully-settled conversion word.

To synchronize multiple converters in a system, the

SYNC pulse should rise on a falling edge of the

MCLK signal. This ensures that the SYNC input to

all CS5181s in the system will be recognized on the

next rising edge of MCLK. Use of the SYNC input

RESET

CS5181

D

Q

CLK Q RESET

MCLK

RESET

FSO

MCLK

SYNC

D

Q SYNC

CLK

MCLK

988205 MCLK Cycles

SYNC

FSO

5161 MCLK Cycles

Figure 2. RESET and SYNC logic and timing.

8

DS250PP1

Share Link: