CDB5321 Просмотр технического описания (PDF) - Cirrus Logic
Номер в каталоге
Компоненты Описание
Список матч
CDB5321 Datasheet PDF : 12 Pages
| |||
CDB5321
10
+5V
R25 0.1 C33
10
+5V
R3 + 10µF 0.1µF 14 U7
2.048 MHz
C2 C1
OSC
8
14 pin
7
74HC74
14
4S
Q5
U5A
3 CLK
2D
1R
Q6
10 S
9
Q
U5B
11
CLK
12
D
13
R
Q8
*2.048 MHz
exceeds the
specified clock
frequency for
the CS5321
J4
CLK/4 (512 kHz)
CLK/2 (1.024 MHz)
CLK (2.048 MHz)*
CLKIN (To Figure 4)
Figure 3. Oscillator / Divider
OFST=1. Figure 3 illustrates the 2.048 MHz os-
cillator and dual D flip flop clock divider. Note
that both the oscillator and the divider are sepa-
rately decoupled from the +5V supply to reduce
clock jitter which can be introduced from noisy
supplies. Jumper J4 should be set in the CLK/2
position to source 1.024 MHz to the CS5322
chip for normal operation. If operation from
512 kHz clock is desired, the J4 jumper should
be changed to the CLK/4 position. The board
can be tested at 512 kHz without modification.
The digital interface pins to the CS5322 filter
chip are all available on the header connectors
J1, J2, and J3 as shown in Figures 4, 5, and 6.
Note that one row of pins on each of the headers
is ground. It is advised that any connections
made to control lines be done with twisted pair
ribbon cable; with each twisted pair containing
one signal and one ground connection. This
minimizes radiated noise.
CAUTION!
Caution is advised when interfacing the evalu-
ation board to any circuitry powered from
another source. For example, when interfacing
to a computer I/O card be sure that the evalu-
ation board and the computer are both powered
up before connecting to the evaluation board
headers. Always disconnect header connections
when powering down the board but not the com-
puter. Failure to follow this advice may cause
damage to either the computer I/O or to the
CS5322, because the computer outputs try to
power the CDB5321 board.
18
DS88DB2
Share Link: 