AT29C040A-12JC Просмотр технического описания (PDF) - Atmel Corporation

Номер в каталоге

Компоненты Описание

Список матч

AT29C040A-12JC

4-megabit (512K x 8) 5-volt Only 256-byte Sector Flash Memory

Atmel Corporation 

3. Block Diagram

AT29C040A

4. Device Operation

4.1 Read

The AT29C040A is accessed like an EPROM. When CE and OE are low and WE is high, the

data stored at the memory location determined by the address pins is asserted on the outputs.

The outputs are put in the high impedance state whenever CE or OE is high. This dual-line con-

trol gives designers flexibility in preventing bus contention.

4.2 Byte Load

Byte loads are used to enter the 256 bytes of a sector to be programmed or the software codes

for data protection. A byte load is performed by applying a low pulse on the WE or CE input with

CE or WE low (respectively) and OE high. The address is latched on the falling edge of CE or

WE, whichever occurs last. The data is latched by the first rising edge of CE or WE.

4.3 Program

The device is reprogrammed on a sector basis. If a byte of data within a sector is to be changed,

data for the entire sector must be loaded into the device. Any byte that is not loaded during the

programming of its sector will be erased to read FFH. Once the bytes of a sector are loaded into

the device, they are simultaneously programmed during the internal programming period. After

the first data byte has been loaded into the device, successive bytes are entered in the same

manner. Each new byte to be programmed must have its high to low transition on WE (or CE)

within 150 µs of the low to high transition of WE (or CE) of the preceding byte. If a high to low

transition is not detected within 150 µs of the last low to high transition, the load period will end

and the internal programming period will start. A8 to A18 specify the sector address. The sector

address must be valid during each high to low transition of WE (or CE). A0 to A7 specify the byte

address within the sector. The bytes may be loaded in any order; sequential loading is not

required. Once a programming operation has been initiated, and for the duration of tWC, a read

operation will effectively be a polling operation.

4.4 Software Data Protection

A software controlled data protection feature is available on the AT29C040A. Once the software

protection is enabled a software algorithm must be issued to the device before a program may

3

0333K–FLASH–2/05

Share Link: