AK4563A Просмотр технического описания (PDF) - Asahi Kasei Microdevices

Номер в каталоге

Компоненты Описание

Список матч

AK4563A

Low Power 16bit 4ch ADC & 2ch DAC with ALC

Asahi Kasei Microdevices 

ASAHI KASEI

[AK4563A]

Power Supply

PDN pin

PDN pin may be “L” at power-up.

ADC Internal

State

PD

4128/fs

INIT

GD

AIN

SDTO0,1

DAC Internal

State

SDTI

AOUT

Control register

“0”data

PD

GD (1)

(4)

INIT-1

INIT-2

W rite to register

Read from register

External clocks

Inhibit-1 Inhibit-2

Inhibit-1

Normal

PM

GD (1)

4128/fs

INIT

Normal

GD

Norm al

(2)

(3) “0”data

Idle Noise

PM

(1)

Norm al

GD (1)

“0”data

(4)

GD (1)

Normal

Normal

Normal

INIT-2

Norm al

(5)

The clocks may be stopped.

Figure 8. Power-up/Power-down Timing Example

• INIT:

Initializing. At this time, STAT bit is “0”. When this flag becomes “1”, INIT process has completed.

IPGA0 and IPGA1 are MUTE state.

• PD:

Power-down state. ADC is output “0”, analog output of DAC goes floating.

• PM:

Power-down state by operating Power Management bit

• INIT-1: Initializing all registers.

• INIT-2: Initializing read only registers in control registers.

• Inhibit-1: Inhibits writing and reading to all control registers.

• Inhibit-2: Inhibits writing to all control registers.

Note: Please refer to “explanation of register” about the condition of each register.

(1) Digital output corresponding to analog input and analog output corresponding to digital input have the group

delay (GD).

(2) If the analog signal does not be input, the digital outputs have the op-amp of input and some noise in ADC.

(3) ADC data is “0” data at power-down.

(4) A few noise occurs at the “↓ ↑” of PDN signal. Please mute the analog output externally if the noise influences

the system application.

(5) When the external clocks are stopped, the AK4563A should be in the power-down mode (PDN pin = “L” or

PM5-0 bit = “0”) .

MS0067-E-02

- 12 -

2004/12

Share Link: