PI5C3303T Просмотр технического описания (PDF) - Pericom Semiconductor
Номер в каталоге
Компоненты Описание
Список матч
PI5C3303T Datasheet PDF : 5 Pages
| |||
PI5C3303
SOTiny™ 2:1 Mux/DeMux Bus Switch
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
Storage Temperature ..........................................................–65°C to +150°C
Ambient Temperature with Power Applied .........................–40°C to +85°C
Supply Voltage to Ground Potential......................................–0.5V to +7.0V
DC Input Voltage ..................................................................–0.5V to +7.0V
DC Output Current.............................................................................120mA
Power Dissipation .................................................................................0.5W
Note: Stresses greater than those listed under MAXI-
MUM RATINGS may cause permanent damage to
the device. This is a stress rating only and functional
operation of the device at these or any other conditions
above those indicated in the operational sections of this
specification is not implied. Exposure to absolute max-
imum rating conditions for extended periods may affect
reliability.
DC Electrical Characteristics (Over the Operating Range, TA = –40°C to +85°C, VCC = 5V ± 10%)
Parameters
Description
Test Conditions(1)
Min. Typ.(2)
VIH
Input HIGH Voltage
Guaranteed Logic HIGH Level
2.0
VIL
Input LOW Voltage
Guaranteed Logic LOW Level
–0.5
IIH
Input HIGH Current
VCC = Max., VIN = VCC
IIL
Input LOW Current
VCC = Max., VIN = GND
IOZ
High Impedence Output Current VCC = Max., VOUT = 0V or VCC
VCC = 4V, VIN = 2.4V,
ION = -15mA
10
RON
Switch On-Resistance(3)
VCC = 4.5V, VIN = 0V,
ION = 30mA or 64mA
4
VCC = 4.5V, VIN = 2.4V, ION = -15mA
7
Max. Units
V
0.8
±1
±1 µA
±1
20
7
Ω
15
Capacitance (TA = 25°C, f = 1 MHz)
Parameters(4)
Description
Test Conditions
Type(4)
Units
CIN
Input Capacitance
3
COFF
A/B Capacitance, Switch Off
VIN = 0V
5
pF
CON
A/B Capacitance, Switch On
12
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at VCC = 5.0V, TA = 25°C ambient and maximum loading.
3. Measured by the voltage drop between A and B pin at indicated current through the switch. On-Resistance is determined by the lower of the
voltages on the two (A, B) pins.
4. This parameter is determined by device characterization but is not production tested.
2
PS8367D
10/14/04
Share Link: 