ZR36057PQC Просмотр технического описания (PDF) - Zoran Corporation

Номер в каталоге

Компоненты Описание

Список матч

ZR36057PQC

ENHANCED PCI BUS MULTIMEDIA CONTROLLER

Zoran Corporation 

Enhanced PCI Bus Multimedia Controller

• The host writes a full doubleword to the PostOffice register,

containing the guest’s identity (0,..,7), the specific guest reg-

ister (0,...,7), and an indication that this is a read request

(direction bit = 0). The data portion of the doubleword is

meaningless, but should be set to a byte of zeros. As a result

of writing to the PostOffice data byte, the PostOffice pending

bit is set to ‘1’.

• The ZR36057 completes the current code-write cycle, if one

is being executed, and before executing the next code-write

cycle (if one is needed), it executes the pending PostOffice

request. It transfers the byte read from the guest to bits 7...0

of the PostOffice register. At the completion of the GuestBus

read cycle it clears the request pending bit.

• The host may read the PostOffice register, to verify that the

pending bit is ‘0’, meaning that the read request has been

completed and the data portion of the PostOffice register is

the result.

• Note that in multiple (back-to-back) PostOffice operations

the host has to poll the request pending bit only once be-

tween two requests, since reading this bit zero indicates

both that the previous request has been completed and that

the next request can be made.

5.5 Codec Bus Interface

The Codec Front End (CFE) interfaces to the ZR36050 JPEG

Codec to transfer code (compressed data) to or from the

ZR36057. The CFE is designed to operate with the ZR36050

configured in Code Bus Master mode. In Compression mode,

the CFE receives the code stream from the codec and transfers

it to the Code FIFO. In Decompression mode, the CFE transfers

the code stream from the Code FIFO to the codec in response

to the codec’s read requests.

The CFE uses the CODE[7..0] bus to transfer the code using the

handshaking signals CCS and CBUSY, synchronized to

VCLKx2. The ZR36057 supports the highest ZR36050 code bus

transfer rate, one clock cycle per byte transfer (ZR36050 CFIS

parameter = 0).

5.5.1 Compression Mode Code Transactions

The functional timing diagram for compression is shown in

Figure 5.

In this example, two code bytes are transferred from the

ZR36050 to the ZR36057. The falling edge of CCS designates

the start of the cycle. The data is driven by the ZR36050 at the

rising edge of VCLKx2. The ZR36057’s Codec Interface

samples the data with VCLKx2 enabled by CCS.

VCLKx2

CCS

CODE[2:0]

(Input)

n

n+1

Figure 5. Compression Mode Code Transactions

5.5.2 Decompression Mode Code Transactions

The functional timing diagram for decompression is shown in

Figure 6.

In this example, two code bytes are transferred from the

ZR36057 to the ZR36050. The falling edge of CCS designates

the start of the cycle. The data is driven by the ZR36057. The

ZR36050 samples the data with the rising edge of COE (note

that COE is not an input to the ZR36057; it is mentioned here

only for the completeness of the description).

VCLKx2

CCS

COE

(Not an Input to

the ZR36057)

CODE[2:0]

(Output)

n

n+1

Figure 6. Decompression Mode Code Transactions

5.5.3 Transaction Termination

The ZR36050 is the master of the code transactions in Compres-

sion and Decompression modes. Any number of bytes can be

transferred in a contiguous burst transaction. The ZR36057 uses

the ZR36050’s CBUSY to block CODE bus transactions, in order

to prevent overflow of the Code FIFO in compression or under-

flow in decompression. Figure 7 shows the functional timing

diagram for CODE bus transaction termination.

The ZR36050 examines CBUSY one clock cycle prior to the

beginning of each access cycle. The ZR36057 asserts CBUSY

one VCLKx2 cycle before the beginning of the last desired code

transfer cycle.

VCLKx2

CCS

COE / CWE

CODE[2:0]

CBUSY

This access is blocked.

Figure 7. Transaction Termination

16

Share Link: