Freescale Semiconductor, Inc.
10. If available, connect an ASCII terminal to J16 (the DB-25 connector on the NT1 side of the board).
Make certain the terminal is set for 9600 baud, 1 stop bit, and no parity. If there is no response,
reverse the EIA-232 Tx and Rx signals by changing the jumpers on JP13.
11. Depress the RESET push-buttons and verify that the ÒNTLT>Ó prompt has appeared on the terminal
screen.
Continue reading this document to learn more about the operation of the MC145572EVK U-Interface
Transceiver Evaluation Kit. As always, please phone the factory for assistance with any problems
encountered while ÒGetting Started.Ó
MC145572EVK
12
For More Information On This Product,
Go to: www.freescale.com
MOTOROLA