KL5KUSB110 Просмотр технического описания (PDF) - KAWASAKI MICROELECTRONICS
Номер в каталоге
Компоненты Описание
Список матч
KL5KUSB110 Datasheet PDF : 4 Pages
| |||
K KAWASAKI
LSI
Preliminary
USB to ATAPI
Description
The KL5KUSB110from Kawasaki , is a low cost, high speed Universal Serial Bus (USB) to ATAPI/IDE
Controller. It's 16 bit RISC processor and built in BIOS ROM translates USB ATAPI host commands to a
wide variety IDE storage devices such as, HDD, FD, CD-ROM, CD-WR, ZIP Drives LS120 drives. The
KL5KUSB110's unique interface architecture to external serial flash EEPROM allows flexibility to upgrade
and support a variety of IDE/ATAPI based disk drives, without changing peripheral hardware. This is
accomplished when new functions are uploaded into the Serial EEPROM from the USB Host PC. The
KL5KUSB110's Memory/GPIO bi-directional Port supports both 8 and 16 bit PIO modes. The USB port
supports up to the maximum 12 Mbits/sec USB transfer rate. All USB protocol modes are supported;
Isochronous ( up to 1024 bytes ), Bulk, Interrupt and Control. The KL5KUSB110 uses IDE as a physical
interface, but commands to the external disk can be either IDE or ATAPI commands. ATA-1,2&3 based
disk drives are also supported. The KL5KUSB110 device supports a wide variety of Disk drive solutions
due to it's Maximum Disk drive throughput rate up to 1Mbytes/sec and comprehensive PnP USB/ATAPI
drivers.
Features
• Advanced 16 Bit processor for USB transaction • Maximum disk throughput up to 1MBytes/sec
processing and control data processing
• I2C interface
• Compliant with the USB 1.0/1.1 (Universal
• Utilizes low cost external crystal circuitry
Serial Bus)
• 3K x 8 internal general purpose buffer.
• Compatible to a wide variety of Storage
• USB host device drivers available
devices.
• Suspend, resume and low power modes
• Data transfer in PIO mode, 8 or 16 bit
• 3.3 Vdd operation
• Plug and Play compatible
• Single-chip solution in a 100 pin LQFP
Block Diagram
Data +
Data -
USB
Interface
Serial
Interface
Engine
X1
PLL & Clock
X2
Generator
CK
I2C
DIO
W atchdog
Timer
Timer 1
Timer 0
16 Bit
Processor
16 Bit Address / Data Bus
RAM
(3KB)
Mask
ROM
EEPROM
Serial
Interface
ATAPI /
IDE
Interface
A1-A3
CS0-CS1
DASP
RD
WR
IO RDY
IO 8/16
RESET
DD0 - DD15
5V logic
CK DIO
Kawasaki LSI • 2570 North First Street • Suite 301 • San Jose, CA 95131 • Tel: (408) 570-0555 • Fax: (408) 570-0567 • www.klsi.com
Ver. 1..0
1
Share Link: 