RP1-1.5V Просмотр технического описания (PDF) - Panasonic Corporation
Номер в каталоге
Компоненты Описание
Список матч
RP1-1.5V Datasheet PDF : 5 Pages
| |||
RP
NOTES
1. Coil operating power
Pure DC current should be applied to the
coil. The wave form should be
rectangular. If it includes ripple, the ripple
factor should be less than 5%.
However, check it with the actual circuit
since the characteristics may be slightly
different. The nominal operating voltage
should be applied to the coil for more
than 20 ms to set/reset the latching type
relay.
2. Coil connection
When connecting coils, refer to the wiring
diagram to prevent mis-operation or
malfunction.
3. External magnetic field
Since RP relays are highly sensitive
polarized relays, their characteristics will
be affected by a strong external magnetic
field. Avoid using the relay under that
condition.
4. Packing direction
Relays are packed in a tube with the
orientation stripe (PIN NO. 1) toward the
green stopper.
Stopper (gray)
Stopper (green)
Orientation (indicates PIN No.1) stripe
5. Automatic mounting
To maintain the internal function of the
relay, the chucking pressure should
not exceed the values below.
Chucking pressure* in the direction A:
4.9 N {500 gf} or less
Chucking pressure* in the direction B:
9.8 N {1 kgf} or less
Chucking pressure* in the direction C:
9.8 N {1 kgf} or less
Please chuck the portion.
Avoid chucking the center of the relay. In
addition, excessive chucking pressure to
the pinpoint of the relay should be
avoided.
A (4) C
(5)
(6)
B
mm inch
• Direction A • Direction B • Direction C
654 3
.118
6
3
12
.236
123
*Value of chucking pressure is shown by the value of weight
pressed on the portion (4 mm .157 inch dia.).
6. Soldering
Preheat according to the following
conditions.
Temperature
120°C 248°F or less
Time
Within 2 minute
Soldering should be done at 260±5°C
500±9°F within 6 s.
For general cautions for use, please
refer to the “General Application
Guidelines”.
All Rights Reserved © COPYRIGHT Panasonic Electric Works Co., Ltd.
Share Link: 