L98SI Просмотр технического описания (PDF) - STMicroelectronics

Номер в каталоге

Компоненты Описание

Список матч

L98SI

OCTAL SERIAL SOLENOID DRIVER

STMicroelectronics 

L98SI

shift register (into the SI pin and out the SO pin), al-

lowing theotherSPI devicesto becascadedin a dai-

sy chain with the L98SI.

CE Low to High Transition

Once the last data bit has been shifted into the

L98SI, the CE pin should be pulled high.

At the rising edge of CE the shift register data is lat-

ched intothe parallel latch and the outputstageswill

be actuated by the new data. An internal 160µs de-

lay timer will also be started at this rising edge (see

tUD). During the 160µs period, the outputs will be

protected only by the analog current limiting circuits

since the resetting of the parallel latches by faults

conditionswill be inhibitedduringthis period.This al-

lows the part to overcome any high inrush currents

that may flow immediately after turn on. Once the

delay period has elapsed, the output voltages are

sensed by the comparators and any output with vol-

tageshigher than 1.8V arelatched OFF. It shouldbe

noted that the SCLK pin should be low at both tran-

sitions of the CE pin to avoid any false clocking of

theshift register. TheSCLK input is gatedby the CE

pin, so that the SCLK pin is ignored whenever the

CE pin is high.

FAULT CONDITIONS CHECK

Checking for fault conditions may be done in the fol-

lowing way. Clock in a new control byte. Wait 160

microseconds or so to allow the outputs to settle.

Clock in thesame controlbyte and observethe diag-

nostic data that comes out of the device. The diag-

nostic bits should be identical to the bits that were

first clockedin. Any differenceswould point to a fault

on that output.If the outputwas programmed ON by

clocking in a zero, and a one came back as the dia-

gnosticbit forthat output,the outputpinwasstill high

and a short circuit or overload condition exists. If the

output was programmed OFF by clocking in a one,

and a zero came back as the diagnostic bit for that

output, nothing had pulled the output pin high and it

Figure 1 : Byte Timing with Asynchronous Reset.

6/9

Share Link: